User Manual

7
Connecting via Bluetooth wireless technology
To connect the product to a Bluetooth device, the product needs to pair (register) with the device.
• Read the user manual for the Bluetooth device.
• Place the Bluetooth device within 1 m (3.3') of the product to perform pairing correctly.
• To confirm the progress of the pairing process, wear the product while performing this procedure and listen for the
confirmation tone.
1. Starting with the product turned off, slide the power switch to the “ON” position.
• The indicator lamp will light in white, and then flash in white.
2. Use your Bluetooth device to begin the pairing process and search for the product.
When your Bluetooth device finds the product, “ATH-CKR300BT” will be displayed on the device.
• For information about using your Bluetooth device, refer to the device’s user manual.
3. Select “ATH-CKR300BT” to pair the product and your Bluetooth device.
• Some devices may ask for a passkey. In this case, enter “0000”. The passkey may
also be called a passcode, PIN code, PIN number, or password.
• The product sounds a confirmation tone when pairing is complete.
100%12:00
Bluetooth ON
ATH-CKR300BT
Pairing a Bluetooth device
When connecting a new Bluetooth device, you need to pair it with the product. Once the Bluetooth device and the
product are paired, you do not need to pair them again. The product supports multipairing, in which a connection
history is saved.
However, in the following cases you will need to pair again even if the Bluetooth device was paired once:
• If the product is deleted from the Bluetooth device’s connection history.
• If the product is sent out for repair.
• When switching to a Bluetooth device, you may not be able to pair
because the previously connected Bluetooth device cannot be
disconnected. In such cases, press and hold (about 6 seconds) the
volume buttons (+/-). The product will switch to the “searching for
devices” state and you will be able to pair with your desired Bluetooth
device.
About pairing