User Manual
Table Of Contents
- Introduction
- Package contents
- Safety precautions
- Notes on use
- Part names and functions
- Preparation for use
- Placing the platter
- Setting up the turntable
- Assembling the tonearm
- Tonearm balance and tracking force
- Setting tonearm balance
- Setting tracking force
- Setting the anti-skate adjustment
- Installing/removing the dust cover
- Setting output selector switch
- Connecting to connectable equipment (active speakers, amplifiers, etc.)
- Connecting the AC adapter
- Playing a record
- Care
- Replacing the stylus
- Replacing a cartridge
- Replacing the belt
- Adjusting the overhang
- When the turntable is moved
- Troubleshooting
- Dimensions
- Specifications
6
Preparation for use
Placing the platter
This product requires some assembly before using it for the first time.
Do not connect the AC adapter until assembly is complete.
1. Set the platter on the spindle.
• Make sure that the control knob is in the "STOP" position.
• To avoid damaging the spindle when seating the platter, align the position
of the spindle and the platter's hole, and then slowly seat the platter.
• Make certain that the platter is fully seated on the spindle.
Spindle
Platter
2. Install the belt to the platter drive ring under the platter making
sure the belt is flat when seated, and then attach the belt to the
motor pulley (brass-colored).
• Make sure that the belt does not get twisted.
Belt
Motor pulley
(brass-colored)
Untwisted
Twisted
3. Place the rubber mat on top of the platter.
Setting up the turntable
• Position the product on a level surface.
• To avoid the effects of vibrations and acoustic pressure, do not
mount the product next to such items as speakers.
• The product may pick up radio static if placed next to a radio.
Therefore, try to keep the product away from radios.
• If the product is near equipment (cell phone, etc.) that emits strong
radio waves, noise may occur.
Leveling the turntable
1. After positioning the product where you want to use it, adjust the
feet so that the product is level.
• Use a level (sold separately) as needed to ensure that the product is level.