Specification

18 - audio-technica phono cartridges guide - 2019/20
Moving coil phono cartridges for mono vinyl LP records
The AT33MONO is made specifically for use on mono LP.
The AT33MONO produces sound to a very high quality because it does not easily
pick up unnecessary strain components from distorted or scratched records,
producing audio that you couldn’t possibly get from a stereo cartridge.
The AT33MONO also has appropriate compliance in the vertical direction to avoid
damage to stereo records.
• Mono cartridge compatible with stereo playback systems.
• 0.65mil conical nude square shank stylus hard duralumin cantilever.
• Strong body stabilized by a rigid body set-up.
•
“Hanenite” anti-vibration high-damping rubber eliminates unnecessary
vibrations.
• High-quality brass fastening screw.
•
Note: this model is not compatible with SP records due to the size of the diamond
(0.6mil) designed for microgroove 33.
1/3
rpm and 45rpm vinyl records.
Made specifically for mono recordings on vinyl records, the cartridge only
generates signal with horizontal movement. However to produce a minimal wear on
the groove, the AT-MONO3/LP also has an adapted vertical compliance.
•
Carefully selected components and state of the art technology produce a high
resolution cartridge.
•
S
traight pipe aluminium cantilever and low mass stylus guarantees a high tracking
ability.
• The average usage time is 500 hours extending the life span of precious mono
recordings.
•
H
igh purity PCOCC allows a more transparent signal transmission both high
eciency and high fidelity.
•
To support the internal mechanism, the body is made of solid die-cast aluminium
alloy, furthermore stiness is achieved with the addition of rigid synthetic resin to
hold the body.
•
N
ote: this model is not compatible with 78rpm SP records due to the size of the
diamond (0.6mil) designed for microgroove 33
1/3rpm records.
AT33MONO internal wiring
This schematics shows the internal wiring of
AT33MONO featuring two horizontal voice
coils each voice coils termination is available
independently per the above diagram.
AT
‑MONO3/LP internal wiring
This schematic shows the internal wiring of
AT‑MONO3/LP featuring two horizontal voice
coils wired in series, resulting electrically as a
single mono voice coil. The mono signal is
available from white‑blue terminals, the same
signal is also available from red‑green
terminals in order to feed both inputs of a
stereo phono preamp.
0.65 mil Conical Stylus
Nude Square Shank
AT33MONO
High-end moving coil mono cartridge
for mono vinyl LP (Long Play) records
399,00 e
Including VAT
EAN 4961310098964
Bonded Conical Stylus
Round Shank
AT-MONO3/LP
High output moving coil mono cartridge
for mono vinyl LP (Long Play) records
199,00 e
Including VAT
EAN 4961310008321