ATS99 Hypercardioid Dynamic Microphone User Manual English
Safety precautions Although this product was designed to be used safely, failing to use it correctly may result in an accident. To ensure safety, observe all warnings and cautions while using the product. Cautions for the product Do not subject the product to strong impact to avoid malfunction. Do not disassemble, modify or attempt to repair the product. Do not handle the product with wet hands to avoid electric shock or injury.
Notes on use Be sure to read the connected device’s user manual before use. When the product is used for a long time, the product may become discolored due to ultraviolet light (especially direct sunlight) and wear. Make sure to hold the plug when connecting and disconnecting the cable. The cable may become severed or an accident may occur if you pull on the cable itself. When using the cable, be careful not to twist it to prevent damage to the cable.
Included accessories 1 2 1 AT8470 stand clamp for 5/8”-27 threaded stands 2 5/8”-27 to 3/8”-16 threaded adapter 3 Pouch 3 3
Using the product 1 Connect the product to a device with a microphone input (balanced input) for use. 2 Use the product with the front part facing the sound source.
Connection procedure The output connector is an XLR-M type with polarity as shown in the figure below.
Cleaning Get into the habit of regularly cleaning the product to ensure that it will last for a long time. Do not use alcohol, paint thinners, or other solvents for cleaning purposes. Wipe dirt off the product with a dry cloth. If the cables become dirty because of sweat, etc., wipe them with a dry cloth immediately after use. Failure to clean the cables may cause them to deteriorate and harden over time, resulting in a malfunction.
Dimensions φ50 φ21.4 181.
Specifications Element Dynamic Polar pattern Hypercardioid Frequency response 60 to 16,000 Hz Open circuit sensitivity -52 dB (0 dB = 1 V/Pa, 1 kHz) Impedance 600 ohms Weight 262 g (9.2 oz) Dimensions 181.5 mm (7.1”) long, 50 mm (2.
Polar pattern/Frequency response Polar pattern 0˚ 30˚ 330˚ 60˚ 300˚ 90˚ 270˚ 120˚ 240˚ 150˚ 210˚ 180˚ LEGEND 200 Hz 1 kHz 5 kHz 8 kHz SCALE IS 5 DECIBELS PER DIVISION Frequency response 10 dB 20 50 100 200 500 1k 2k 5k 10k Frequency in Hertz LEGEND 0°, 50 cm 9 20k Response in dB 60 - 16,000 Hz
株式会社オーディオテクニカ 〒194-8666 東京都町田市西成瀬2-46-1 www.audio-technica.co.jp Audio-Technica Corporation 2-46-1 Nishi-naruse, Machida, Tokyo 194-8666, Japan www.audio-technica.com ©2022 Audio-Technica Corporation Global Support Contact: www.at-globalsupport.com 142420770-02-01 ver.1 2022.11.
