System 10 Installation and Operation Reva] A RISK OF ELECTRIC SHOCK A DO NOT OPEN WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT REMOVE SCREWS. NO USER-SERVICEABLE PARTS INSIDE REFER SERVICING TO QUALIFIED SERVICE PERSONNEL, WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THE APPLIANCE TO RAIN OR MOISTURE, CERTIFICATION: THIS DEVICE COMPLIES WITH PART 16 OF THE FCC RULES.
System 10 Installation and Operation Because Stern 10 packaging is designed 10 hold afl versions of the stern, some compartments in the carton may be intentionally lat empty. The AT W-R1100 receiver includes a switching power supply that automatically adapts to changes in mans voltage. The versatile AT W-T1001 Bakunin body pack transmitter has both a high-impedance input for instruments, and a low-impedance input with bias connection for use with dynamic and electric condenser microphones.
System 10 installation and Operation AT W-T1002 Transmitter Setup Controls and Functions Battery Selection and Installation Two alkaline AA batteries are recommended. When inserting the battery, observe correct polarity as marked inside the battery compartment. Power / Battery / Mute ‘Status Indicator Level Control © En EE System 1D Display Fairing Switch Bauer Component Screwdriver OEENER® Figure © — ATW.
System 10 Installation and Operation Microphone { Instrument Level Control jj Pairing Switch rer Screwdriver Stamina ID Display =a ££ Buttery Compartment Figure D — AT W-T1001 UniPak® Transmitter UniPaic® Transmitter Battery Installation 1. Slide off the battery cover. 2. Carefully insert two fresh AA alkalizing batteries, observing polarity roastings. 3. Replace the battery cover (Fig. Di.
8 System 10 Installation and Operation System Operation Turn down the receiver volume control and the mixerfsmplitier level before starting up the wireless system. Do not switch on the transmitter yet. Receiver on... Plug the power supply into an AC power source. The blue Stern ID number on the grant panel wall illuminate “Transmitter on...
System 10 Installation and Operation Note: While unique System ID numbers are not required, we recommend assigning unique System II) numbers far each transmitter receiver pair. As noted previously, Stern ID numbers are not related to transmitter frequency; they are provided for user convenience only. *if transmitter pair button is not pushed within 30 seconds, the system will revert to its previous settings. Ten Tips to Obtain the Best Results 1.
Register your product online at (audio-technica. Audio-Technical U.S., Inc.
U.S. Two-Year Limited End-User Warranty This product and selected Audio-Technical brand products purchased in the U.S.A. from an authorized Audio-Technical dealer are warranted for two years from date of purchase by A TU.S. to be free of defects in materials and workmanship. To identify those products, go to In event of a defect, End-Users exclusive remedy is at A TU.S! election, the cost of repair, refund of the purchase price in the form of credit or cash, or replacement of the product.