User Manual

ManualsBrandsAudio-Technica ManualsPro AudioATW-3211/831 3000 Series Wireless Cardioid Lavalier Microphone System

Setting ATW-R3210

Setting the audio output level

1. From the menu screen, turn the control dial, select [AUDIO] and

then press the control dial.

2. Turn the control dial to set the audio output level.

• The level changes 2dB +/- each time you turn the control dial.

• It can be set from -60 to 0dB.

3. Press the control dial.

• The setting is complete.

Scanning for open channels

Scan for unused channels in the current environment for use.

1. From the menu screen, turn the control dial, select [GROUP

SCAN] and then press the control dial.

2. Turn the control dial to select the group you want to scan. After

selecting a group, press the control dial.

3. Turn the control dial to select the preferred threshold. After

selecting the threshold, press the control dial.

• You can select [Normal], [High] or [Low] sensitivity.

High: Prioritize the number of channels.

Normal

Low: Prioritize stable operation.

• Scan starts.

4. Confirm the scan result by selecting [OK] and then pressing the

control dial.

• If you want to scan over again, select [Retry].

5. Available channels and frequencies are shown in a list. Turn the

control dial, select an available channel and then press the

control dial.

• The setting is complete.

Setting transmitters via IR SYNC

This function allows you to make transmitter settings on the receiver

and then automatically configure the transmitter via IR SYNC. The

following are the available settings and setting values:

Settings Setting values

Freq Current setting value, NoChange

Name Current setting value, NoChange

RF Pwr Low:10mW, High:30mW, NoChange

Gain -10 to +20dB, NoChange

Lock Lock, Unlock, NoChange

Batt Alkaline, Ni-MH, NoChange

HPF OFF, ON, NoChange

1. From the menu screen, turn the control dial, select [TX SYNC]

and then press the control dial.

2. Turn the control dial to select a setting you would like to sync to

the transmitter and then press the control dial.

3. Turn the control dial to select the setting value and then press

the control dial.

4. Repeat Steps 2 and 3 for each setting you would like to sync to

the transmitter.

5. Turn the control dial, select [SYNC START] and then press the

control dial.

• Communication function is in standby.

Refer to "Using IR SYNC" (p. 25) for subsequent steps.