Pro Series 5 UHF Wireless Systems Installation and Operation PRO-501 UniPak® Transmitter System PRO-501/G Guitar System PRO-501/H Headworn Microphone System PRO-501/H92 Miniature Headworn Microphone System PRO-501/H92-TH Miniature (beige) Headworn Microphone System PRO-501/L Lavalier Microphone System PRO-502 Handheld Microphone System
Pro Series 5 Installation and Operation This device complies with part 15 of the FCC Rules. Operation is subject to the condition that this device does not cause harmful interference. Transmitters in the Pro Series 5 use two 1.5V AA batteries for economical operation and wide availability. Both transmitters also feature a multi-color Power/Mute/Battery indicator. This device complies with INDUSTRY CANADA R.S.S. 210, en conformité avec IC: RSS-210/CNR210.
Pro Series 5 Installation and Operation Receiver Controls and Functions 1 2 3 Figure A — Front Panel Controls and Functions 1. ANTENNAS: Position the antennas as shown in Figure A Fully extend both antennas by pulling on the endcaps. 2. AF PEAK INDICATOR: Indicates when maximum transmitter modulation without distortion has been reached. Not affected by position of Volume control (Fig. B). 3. LED WINDOW: LED Display indicates channel setting and scanning operation. 4.
Pro Series 5 Installation and Operation Transmitter Setup, Controls and Functions Battery Selection and Installation Two alkaline AA batteries are recommended. When inserting the battery, observe correct polarity as marked inside the battery compartment. Trim Control (Volume) Screwdriver Figure C — Handheld Transmitter Channel Selector Switch Battery Compartment Indicator LED (Power/Mute/Battery) Handheld Transmitter Battery Installation 1.
Pro Series 5 Installation and Operation Screwdriver Transmitter Door Transmitter Door (Open Positon) Channel Selector Switch Figure D — UniPak® Transmitter RF Power Select Switch Instrument Trim Control (Volume) Microphone Trim Control (Volume) Transmitter Door Catch UniPak® Transmitter Battery Installation 1. Open the transmitter door by first pulling the catch down and then sliding the door upward (Fig. D). 2. Observe correct polarity as marked and carefully insert two fresh 1.
Pro Series 5 Installation and Operation System Operation Plug in the receiver. Receiver on... The LED display will light up. If either A or B diversity indicators lights up at this point (without transmitter on) there may be interference in the area. If this occurs, change the operating channel. How to Make Operating Channel Changes Operating channel changes (frequency changes) may be made in two ways: manually and automatically.
Pro Series 5 Installation and Operation 6. For MIC: While again speaking/singing into the microphone at typically loud levels, adjust the mixer’s input trim control so the highest sound pressure level going into the microphone causes no input overload in the mixer, and yet permits the mixer’s channel and output level controls to operate in their “normal” range (not set too high or too low).
Pro Series 5 Installation and Operation Specifications Overall System UHF Operating Frequency Number of Channels Frequency Stability Modulation Mode Maximum Deviation Operating Range Operating Temperature Range Frequency Response Receiver Receiving System Image Rejection Signal-to-noise Ratio Total Harmonic Distortion Sensitivity Audio Output Unbalanced Balanced Output Connectors Unbalanced Balanced Power Supply Dimensions Net Weight Accessory Include