System 10 Digital Wireless System Installation and Operation ATW-1101 UniPak® Transmitter System ATW-1101/G Guitar System ATW-1101/H Headworn Microphone System ATW-1101/H92 Miniature Headworn Microphone System ATW-1101/H92-TH Miniature (beige) Headworn Microphone System ATW-1101/L Lavalier Microphone System ATW-1102 Handheld Microphone System
System 10 Installation and Operation CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT REMOVE SCREWS. NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THE APPLIANCE TO RAIN OR MOISTURE. CERTIFICATION: THE ATW-1101 COMPLIES WITH PART 15 OF THE FCC RULES. THIS DEVICE COMPLIES WITH INDUSTRY CANADA LICENSE-EXEMPT RSS STANDARD(S).
System 10 Installation and Operation Each System 10 professional digital wireless system includes a receiver and either a body-pack transmitter or a handheld microphone/ transmitter. ATW-1101 UniPak® body-pack transmitter systems include models pre-packaged with either an AT-GcW guitar cable (/G), a PRO 8HEcW headworn microphone (/H), a PRO 92cW headworn microphone (/H92), a PRO 92cW-TH headworn microphone (/H92TH), or an MT830cW lavalier mic (/L) for particular applications.
System 10 Installation and Operation ATW-T1002 Transmitter Setup Controls and Functions Battery Selection and Installation Two alkaline AA batteries are recommended. When inserting the battery, observe correct polarity as marked inside the battery compartment. Power / Battery / Mute Status Indicator Level Control System ID Display Pairing Switch Battery Compartment Screwdriver Figure C — ATW-T1002 Handheld Transmitter Handheld Transmitter Battery Installation 1.
System 10 Installation and Operation Microphone / Instrument Level Control Pairing Switch Screwdriver System ID Display Battery Compartment Figure D — ATW-T1001 UniPak® Transmitter UniPak® Transmitter Battery Installation 1. Slide off the battery cover. 2. Carefully insert two fresh AA alkaline batteries, observing polarity markings. 3. Replace the battery cover (Fig. D).
System 10 Installation and Operation System Operation level before starting up the wireless system. Do not switch on the transmitter yet. Receiver on... Plug the power supply into an AC power source. The blue System ID number on the front panel will illuminate. Transmitter on...
System 10 Installation and Operation Clearing Individual ID Pairings 1. Press the receiver’s System ID button to select the ID number you wish to clear. The number will begin to blink. 2. Press and hold the Pair button and, while continuing to hold it, press and hold the ID button until the display shows a blinking “o.” This indicates that your selected ID number has been cleared. 3. Release the Pair and ID buttons and, after a few seconds, the display will stop blinking and return to normal operation.
System 10 Installation and Operation OVERALL SYSTEM Operating Frequencies Dynamic Range Total Harmonic Distortion Operating Range 2.4 GHz ISM band (2400 to 2483.5 MHz) >109 dB (A-weighted), typical <0.
