2000 Series Professional UHF Wireless Systems ATE-2110 UniPak™ Transmitter System ATE-2120 Handheld Dynamic Microphone System Installation and Operation (biotechnological.
Professional UHF Wireless Systems Installation and Operation This device complies with part 15 of the FCC Rules. Operation is subject to the condition that this device does not cage harmful interference. This device complies with INDUSTRY CANADA R.S.S 214, en conformity ave IC: Operation is subject to the following conditions: 1} This device may nat cause harmful interference and 2) this device must accept any interference received, including interference which may cause undesired operation.
Receiver Installation Location For best operation the receiver should be at least above the ground and at least 3 ft. away from a wall or metal surface to minimize reflections. The transmitter should be at least 3 ft. from the receiver, as shown in Figure A. Keep antennas away from noise sources such as digital equipment, mayors, automobiles and neon fights, as well as away from large metal objects. Output Connections There are two audio outputs on the back panel: balanced {12.5 mV} and unbalanced (25 mv).
Li Figure B-Front Panel Controls and Functions oO o 1. POWER SWITCH: Press the Power switch in to tum the receiver on. The LCD window will light, and the operating channel number will be displayed in the window. To turn the receiver off, press the Power switch again. 2. LCD WINDOW: Liquid Crystal Display indicates channel setting and operational readings. See Fig. C for examples. 3. UP/DOWN BUTTONS: Press Up or Down mow buttons to arrive at desired channel. The selected number wil flash on and off.
Receiver Controls and Functions. continued) Figure D-Rear Panel Controls and Functions 2 $ £5200 four Ee 10. ANTENNA INPUT JACK: ENC-typs antenna connector for Tuner "B." Attach the antenna directly, or extend it with a {ow-loss antenna cable. See the “Antennas” section on page 3 for more details. 11. SQUELCH CONTROL: Adjusts level of noise-muting circuit {preset at factory but can be adjusted as circumstances warrant). Factory setting is full counterclockwise. 12. ANTENNA INPUT JACK: Input for Tuner "A.
Transmitter Controls And Functions. Battery Selection Tw 1.6 AA alkaline batteries are recommended UniPak™ Transmitter Battery installation 1. Open the transmitter door by pressing gently on the side-cover indentations and pulling back the hinged cover shown In Fig. E below. 2. Lift the battery-keeper arm, and carefully insert two fresh 1.5 AA alkaline batteries, observing correct polarity as marked inside the battery compartment. 3. Close the battery-keeper arm. 4. Close the transmitter door.
LI CR a ree) Switch on the receiver. Do not switch on the transmitter yet. Receiver On... The LCD display will Hunt up and one of the tuner operation indicator LCD segments {A or B} will fight, even though the transmitter is not on. If two or more of the RF LCD segments fight up at this point, thees may be RF interference in the area If this occurs, change operating channels {select another frequency).
System Operation (continue: Setting Levels {Continued} AT W-T210 Unifak™ Transmitter Trimmer adjustments in the UniPak™ transmitter (Fig, E) will enable you 10 use microphones or instruments with different output levels. 1. For MIC: Set microphone level trim control fully clockwise {maximum} and instrument revel trim control fully counterclockwise (minimum. For INSTRUMENT: Set instrument level trim control fully clockwise (maximum) and microphone level trim control fully counterclockwise {minimum}. 2.
OVERALL SYSTEM UNIPAK™ TRANSMITTER Pertaining Frequency UE band, 656.125 to 678.500 MHz AF Power Gut pat ZW Huber of Channels 74 total Spurious Emissions Under federal regulations Frequency Sta nifty +05005%, Phase Look Loop redundancy input Connections High impedance, low impedance, bias control Batteries (not included) TG 1.
2000 Series Frequency Channel Plan Channel Frequency Hz TV Channel ! 656.125 as 2 659.378 3 860.000 4 862.125 a8 ee Br. £05.128 — SN 8 663.750 47 nL 671800... en 8 677.000 48 8 678.125 18 BTE.500 Note: All frequencies selected to avoid standard analog TV carrier interference. Ten Tips to Obtain the Best Results Use only fresh alkaline batteries.
One-Year Limited Warranty Audio-Technical professional wireless systems purchased in the U.S.A. are warranted for ane year from fete of purchase by Audi Technical US. fc. {TAUS] to ve free of defects in materials and workmanship. In event of such defect, product will be repaired promptly without charge or, at our option, replaced with 8 new product of equal or superior value If delivered to TAUS. or an Authorized Service Center, prepaid, together with the sales ship or other proof of purchase date.
