Service manual

TECHNICAL SERVICES INFORMATION SHEET
DSS PROGRAMMING
SEPTEMBER 29, 1999 Page 2 of 2
DSS Programming
Page 2
This process will continue until the programming is complete for the number of presets you have selected. Your client may
want a specific station attached to press and hold function. All the stations are determined by your programming. After the
last GROUP is entered, the programming display shows the source selection screen for LEARN IR. From there you may
program IR commands for other sources or press STORE/ENTER twice to exit programming mode.
SAMPLE # 2: (SEE FIGURES 2A/2B )
The second method uses the “Custom Guide” of the DSS to program desired stations, and the PX-600 to control it. However,
you take away the “Custom Guide” from the client in the following manner.
A. The “channel up/down” buttons will only scan the stations contained in the “Custom Guide”.
B. Your client will need to use the other “Guides” available to change channels on the DSS during regular DSS viewing.
The advantage to this method is the ability to program as many stations as are available on the Custom Guide.
LOW CAP CD, AUX, TAPE, or VIDEO can be used on the PX-600 to control the DSS. We’ve included samples from TAPE
or CD under AUX programming.. Again, a POWER command is necessary if the unit does have discrete IR power, if you
wish to have the source turn on and off with the system.
Figure #2A (TAPE)Figure #2A (TAPE)
SAMPLE PROGRAMMING TABLE FOR Sony DSS
PX-600 DISPLAY DSS IR REMOTE BUTTON
NUMBER OF TAPES 1
INPUT IR FOR PLAY CHANNEL UP /CUSTOM GUIDE
INPUT IR FOR STOP NOT USED
INPUT IR FOR FORWARD PLAY CHANNEL UP
INPUT IR FOR REVERSE PLAY CHANNEL UP
TAPE !A CHANNEL DOWN
TAPE 1B NOT USED
Figure #2B (CD)Figure #2B (CD)
SAMPLE PROGRAMMING TABLE FOR Sony DSS
PX-600 DISPLAY DSS IR REMOTE BUTTON
NUMBER OF DISCS 1
INPUT IR FOR PLAY CHANNEL UP/CUSTOM GUIDE
INPUT IR FOR STOP NOT USED
INPUT IR FOR SKIP TRACK CHANNEL UP
DISC 1A CHANNEL DOWN
DISC 1B NOT USED