Service manual

Madrigal Audio Laboratories
P.O. Box 781
Middletown, CT 06457-0781
[phone]
FAX [phone]
Technical Services
Information Sheet
PROGRAMMING DMX ON THE AUX INPUT
AUGUST 10, 1995
Page 1 of 1
DMX Programming on PX-600
Page 1
DOC# AA81095
WB-TS / FB-DW
OVERVIEW
The following procedure should be used to program a DMX on the AUX input. The system will control the DMX unit in an
individual channel advance and/or preset channel advance, See Figure#1.
PROGRAMMING
1. Go to LEARN IR.
2. Go to AUX.
3. Go to CD.
4. Enter number of discs as 10 or the number of presets you intend to use.
5. At AUX POWER enter the power command for the DMX.
6. Skip the PLAY and STOP sections for entering IR codes (leave those addresses in memory empty).
7. At SKIP TRACK enter the DMX code for channel advance (the tune up button).
8. In all the disc “A” prompts enter the DMX code for PRESET.
9. In all the disc “B” prompts enter the number of the preset that you wish to access. The easiest way is to start at 1 through
9 and then end with 0, which will be the 10th preset.
10. Follow the example below
FIGURE # 1FIGURE # 1
SAMPLE PROGRAMMING TABLE FOR scientific Atlanta DMX
MRX / PX-600 DISPLAY DMX IR REMOTE BUTTON
INPUT IR FOR AUX POWER POWER
INPUT IR FOR AUX PLAY NOT USED
INPUT IR FOR AUX STOP NOT USED
INPUT IR FOR AUX SKIP TRACK ADVANCE CHANNEL
INPUT IR FOR AUX DISC 1A PRESET
INPUT IR FOR AUX DISC 1B 1
INPUT IR FOR AUX DISC 2A PRESET
INPUT IR FOR AUX DISC 2B 2
INPUT IR FOR AUX DISC 3A PRESET
INPUT IR FOR AUX DISC 3B 3
INPUT IR FOR AUX DISC 4A PRESET
INPUT IR FOR AUX DISC 4B 4
INPUT IR FOR AUX DISC 5A PRESET
INPUT IR FOR AUX DISC 5B 5
INPUT IR FOR AUX DISC 6A PRESET
INPUT IR FOR AUX DISC 6B 6
INPUT IR FOR AUX DISC 7A PRESET
INPUT IR FOR AUX DISC 7B 7
INPUT IR FOR AUX DISC 8A PRESET
INPUT IR FOR AUX DISC 8B 8
INPUT IR FOR AUX DISC 9A PRESET
INPUT IR FOR AUX DISC 9B 9
INPUT IR FOR AUX DISC 10A PRESET
INPUT IR FOR AUX DISC 10B 0
This process will continue until the programming is complete for the number of presets you have selected. After the last disc
B is entered, the programming display shows the source selection screen for LEARN_IR. From there you may program IR
commands for other sources or press STORE/ENTER twice to exit programming mode.
If there are any questions regarding this programming procedure please call our Customer Support Department
at 860-346-0896.