Specifications

13
ZONE, SYSTEM and ROOM code settings are the same for the DIP switches on the KPS
keypads (see the PX-600 Installation Manual for a description of KPS switches 9 and 10).
PX-603 rooms that are controlled by KPS keypads must have both the PX-603 Room Con-
figuration DIP switches and KPS DIP switches set in the manner described above, rather than
as in the PX-600 Installation Manual. Room setting for KPSs in the main room of the zone is
0 – switches 4 and 8 down.
Here are a few additional examples of possible DIP switch settings:
1
2
345678
Zone 2, Main Room, System 1
1
2
345678
Zone 6, Room 1, System 2
1
2
345678
Zone 5, Room 2, System 0
1
2
345678
Zone 3, Room 3, System 3
}
}
}
}
EQ
You may wish to increase the bass level of one or more PX-603 rooms. The numbered EQ
DIP switches allow you to add 3 dB of “bass boost” to the corresponding room by changing
the EQ dip switch associated with that room to the "UP" or "ON" position.
Power Cord (Grounding)
Connect the AC power cord to the rear panel of the PX-603 and then to a properly grounded
AC outlet. Make all of the remaining connections with the power cord plugged in (for
grounding) and the AC power switch OFF.
PX-603 Programming
You will program most of the setup at the PX-600 with the PX-600 Programmer. Press the PGM
button on the programmer to bring up the MAIN MENU. To select an option or set a value,
use the
▲ and ▼ buttons to highlight the appropriate choice or change the alphanumeric value
and then press ENTER to confirm your selection. Changes to general PX-600 programming
instructions follow. Refer to the PX-600 Installation Manual for complete system programming
instructions.