Owner`s manual

Charging

WARNING!!!

Before making or breaking any electrical connections, please make sure to

read the following instructions on how to properly charge and discharge the capacitor.

Not following the charge / discharge instructions can lead to permanent damage to the

capacitor, which is not covered under the manufacturer warranty.

Charging

 Aftermountingthecapacitorinitsnalposition,attachthegroundtotheca-

pacitor and the chassis grounding location. Next hold the supplied bulb between the

(+) positive battery lead and the (+) positive terminal of the capacitor. If using a bulb, it

shouldlightupforashorttime(normally15-30secondsorso)andthengoout.After

waiting for the capacitor to charge, remove the bulb or resistor and immediately attach

the power (+) cable to the capacitor. The best way to ensure the cap is charged best is

to keep the bulb attached until you touch the main power (+) wire to the capacitor, then

remove it.