Owner`s manual

Installing And Mounting
6
For maximum performance, the capacitor should be installed as close to your
amplier(s)aspossible.Theideallocationisonewhichallowsforshortwiringruns
whilekeepingthecapacitorssomewhatisolatedfromtheheatcreatedbytheamplier
system. The positive (+) power wire should be kept as short as possible and be con-
nectedtotheamplier’sbatterysupplyinput.Werecommendthatahighperformance
distribution block be used to create a splice into this cable (see Fig. 1). You may also
use the capacitor itself as a distribution block by adding multiple power wires to the
terminals located on the top of the capacitor.
 Nofusesshouldbeinstalledinthewirebetweenthecapacitorandtheamplier
system (make sure there is an appropriate fuse at the battery in the main power supply
cable). The ground cable for the capacitor should also be made as short as possible
and be connected directly to the vehicle chassis at a bare metal location. Do not ground
thecapacitordirectlytotheampliergroundterminalorgroundcable.Thecapacitor
and all other components in the system should be grounded using separate ground
cables. It is ok to ground them to the same point on the chassis or frame, just not con-
nected directly to eachother. (see Fig. 1) The positive (+) and negative (-) wires for the
capacitorshouldbethesamegaugeastheamplier’spowerandgroundcables.
Max 24 inches to
amp reccomended
for power wire