Owner`s manual

Troubleshooting

Should you encounter a problem with your capacitor, you can follow the steps

below to make sure that it is working properly.

1. Follow all power (+) and ground (-) connections to and from the capacitor.

Make sure there are no kinks in the wire and no cuts either. If there is a problem in the

wiring, make sure to use new wire and place the wire in a good location where it will not

be roughed up and abused.

2. If using a capacitor with a digital display, you can visually check the capacitor

to see if it is functioning correctly. After charging the capacitor with the provided bulb,

remove the bulb and attach the power wire. If the volt-meter changes slowly, then the

capacitor is properly holding the charge. If the display rapidly decreases and shuts off,

then the cap is not properly holding a charge.

 3.Inthecasethatyoundthatstep2showsyourcapacitorisnotholdinga

charge, you may want to take the capacitor to an authorized dealer to have them run a

capacitance test on the capacitor.