By AMC65H / AMC50H OWNER’S MANUAL
FEATURES & SPECIFICATIONS FEATURES POLYPROPYLENE CONE BUTYL RUBBER SURROUND 2-LAYER HIGH-TRMP ASV VOICE COIL 4 OHM IMPEDANCE COMPONENT MATHED 12dB PER OCTAVE CROSSOVER NETWORK 30mm SILK DOME TWEETER COMPLETE WITH MOUNTING HARDWARE STRONTIUM MID-WOOFER MAGNET NEODYNIUM TWEETER MAGNET POWER HANDLING AMC50H: 120 RMS POWER 260 WATTS ACHIEVABLE AMC65H: 160 RMS POWER 300 WATTS ACHIEVABLE AMC50H: 50Hz - 22.5kHz AMC65H: 40Hz - 22.5kHz FREQUENCY MAGNET WEIGHT AMC50H: 6.5oz. AMC65H: 8oz.
installation It is always best to plan the complete installation prior to attempting to install any product. The routing of wires, power connections and mounting locations should be planned first. As with any car stereo installation, and all work performed should be checked thoroughly and carefully prior to the operation of the system. The placement of your Audiobahn speakers within your vehicle will greatly affect the overall performance of your audio system.
installation Wiring Audiobahn recommends using at least 18-gauge wire with your new speaker system. Thinner gauge wire may easily be severed and can cause damage to your system should any bare wires come in contact with the vehicles chassis. Make sure that your audio system is off while installing and connecting your new Audiobahn speaker. Failure to do so could result in damaging the speaker beyond repair. This is not something that would be covered under the manufacturer warranty.
choosing a location
Troubleshooting In the event that your Audiobahn speakers appear to require service we ask that you first do a little troubleshooting to determine if the problem is actually the speaker, or a problem located in a different part of the vehicle such as the amplifier, wiring, fusing or possibly the source unit.
