ATB10AJ / ATB12AJ OWNER’S MANUAL PLEASE READ THIS MANUAL BEFORE OPERATING THIS UNIT. RETAIN FOR FUTURE REFERENCE.
The Audiobahn Way To bring the product to market that excites the consumer through sound and vision from an orientation of integrity and customer service. We make you look as good as you sound. We strive to take car audio to an extreme the world has never seen, and a world that never stops evolving.
TABLE OF CONTENTS Introduction___________________________________________________ 3 Contents of Carton_____________________________________________ 4 Mounting_____________________________________________________ 5 Controls and Functions__________________________________________ 6 Operation_____________________________________________________ 7 Specifications__________________________________________________ 8 Troubleshooting________________________________________________ 9 Warning and Discla
INTRODUCTION 3 Dear Customer, Congratulations on your purchase of the worlds finest brand of car audio products. Here at Audiobahn Inc. we are devoted to making our musical reproduction the vert best, and we are pleased you have chosen our product. Through years of engineering expertise, hand craftsmanship, and critical testing procedures, we have created a wide range of products that reproduce music with all the clarity and richness you deserve.
Contents of Carton 4 • • • • Amplified Subwoofer with Flame Grill Installation & Operation Manual Warranty Card Power Cable with Fuse and Ring Terminal Ground Wire with Ring Terminal Heat Shrink and Zip Ties • • • • 18 Gauge Remote Turn on Wire Bass Knob with Cord 1 Fuse High Level Input Harness Sticker Dog Tag 1. Make sure to carefully read and understand the instructions before attempting to install your new Audiobahn tube. 2.
Mounting 5 The mounting position of your amplified tube will have a great effect on the sound performance produced. TRUNK MOUNTING Mounting the tube in the trunk provides a good overall performance. PASSENGER COMPARTMENT MOUNTING Mounting the tube in the passenger compartment provides optimum sound, but reduces the area for passenger seating. LOADING Facing the tube towards a wall will increase the low frequency sounds. Use one of the two following signal connections RCA Cable Connection 1.
Controls And Functions 6 L HI-IN R REM L PROT GAIN L.P.F. BASS MIN MAX 40Hz 250Hz 0dB 18dB R LOW-IN +12 PWR Splice into source unit's speaker wires REM GND PWR Connect to chassis ground of vehicle Connect to positive lead / (Blue) wire.
Operation 7 REMOTE BASS BOOST KNOB Mounting and Installation 1. Using the screws provided with the kit, find a location under the dash, center console, or a place that gives easy access to the remote bass boost knob. 2. Plug in the supplied cord into the back of the bass boost knob. Adjusting the Gain To adjust the gain setting, first turn the amplifier gain all the way down. Then turn the source volume up until distortion is audible, and then turn it down until distortion is inaudible.
Specifications 8 Model Number Power RMS Frequency Response: ATB10AJ 100 Watts 30Hz-250Hz ATB12AJ 120 Watts 0Hz-250Hz Overall Dimensions: Height: Width: Length: 11 3/8” 11 1/2” 21 1/8” 13 1/2” 13 3/8” 22 5/8” Weight 25lbs. 30lbs.
Troubleshooting 9 SYMPTOMS NO SOUND AMP NOT SWITCHING ON CHECK POINTS CURE Is the power LED illuminated ? ( NO ) Check fuses in amplifier. Be sure Turn-on lead is connected Check signal leads. Check gain control. Check Tuner/Deck volume level. Clean contacts on fuse holders. Is the Diagnostic LED illuminated ? ( YES ) Check for speaker short or Amplifier overheating. No power to power wire Repair power wire or connections. No power to remote wire with receiver on Check connections to radio.
Warning And Disclaimer 10 Investigate the layout of your automobile thoroughly before drilling or cutting any holes. Take care when you work near gas tanks, gas lines, hydraulic lines, and electrical wiring. Do not use the power amplifier unmounted. Attach the system securely to the automobile to prevent damage, particularly in the event of an accident. Do not mount the system so that the wire connections are unprotected or are subject to pinching or damage from nearby objects.
Warranty 11 Audiobahn Consumer Product Warranty Policy Audiobahn products are manufactured with the highest quality components and some of the most advanced technology available. Because of this we recommend that you have your new products installed by an Authorized Audiobahn Dealer. (A list of Authorized Audiobahn Dealers can be found on our web page). Warranty Period: One year from the original date of purchase. Warranty Coverage: This warranty covers manufacturer defects only.
Warranty Continued 12 How to receive warranty service: Contact your local Authorized Audiobahn Dealer, or call Audiobahn at (714) 452.1476 between the hours of 9:00AM and 5:00PM PST. If you are having problems with your system, we recommend you check the product carefully and thoroughly to confirm that the product truly has a manufacturer defect; as opposed to abuse, or other components in the system caused the failure.
Notes 13
Notes 14
7050 Village Drive, Bldg G Buena Park, CA 90621 714-452-1476 office 888-880-8469 fax info@audiobahn.