User`s manual

SIP User's Manual 222 Document #: LTRT-83303
Mediant 1000 & Mediant 600
4. Click the Submit button to save your changes.
5. To save the changes to flash memory, refer to ''Saving Configuration'' on page 265.
Notes:
• The 'Caller Display Information' page is relevant only for FXS and FXO
interfaces and applicable only to Mediant 1000.
• If Caller ID name is detected on an FXO line (EnableCallerID = 1), it is
used instead of the Caller ID name defined on this page.
• When the 'Presentation' field is set to 'Restricted', the Caller ID is sent to
the remote side using only the P-Asserted-Identity and P-Preferred-
Identity headers (AssertedIdMode).
• The value of the 'Presentation' field can be overridden by configuring the
'Presentation' field in the 'Source Number Manipulation' table (refer to
''Configuring the Number Manipulation Tables'' on page 190).
• You can also configure the Caller Display Information table using the ini
file table parameter CallerDisplayInfo (refer to ''Analog Telephony
Parameters'' on page 355).
3.4.5.6.4 Call Forward
The 'Call Forwarding Table' page allows you to forward (redirect) IP-to-Tel calls (using SIP
302 response) originally destined to specific device ports, to other device ports or to an IP
destination.
Notes:
• The 'Call Forwarding Table' page is relevant to FXS and FXO interfaces.
In addition, it is applicable only to Mediant 1000.
• Ensure that the Call Forward feature is enabled (default) for the settings
on this page to take effect. To enable Call Forward, use the parameter
EnableForward (''Supplementary Services'' on page 176).
• You can also configure the Call Forward table using the ini file table
parameter FwdInfo (refer to ''Analog Telephony Parameters'' on page
355).