User`s manual

Version 5.4 223 May 2008
SIP User's Manual 3. Web-Based Management
¾ To configure Call Forward per port, take these 4 steps:
1. Open the 'Call Forward Table' page (Configuration tab > Protocol Configuration
menu > Endpoint Settings submenu > Call Forward page item).
Figure 3-89: Call Forward Table Page
2. Configure the Call Forward parameters for each port according to the table below.
3. Click the Submit button to save your changes.
4. To save the changes to flash memory, refer to ''Saving Configuration'' on page 265.
Table 3-49: Call Forward Table
Parameter Description
Forward Type
Determines the scenario for forwarding a call.
 [0] Deactivate = Don't forward incoming calls (default).
 [1] On Busy = Forward incoming calls when the port is busy.
 [2] Unconditional = Always forward incoming calls.
 [3] No Answer = Forward incoming calls that are not answered within
the time specified in the 'Time for No Reply Forward' field.
 [4] On Busy or No Answer = Forward incoming calls when the port is
busy or when calls are not answered within the time specified in the
'Time for No Reply Forward' field.
 [5] Do Not Disturb = Immediately reject incoming calls.
Forward to Phone
Number
The telephone number or URI (<number>@<IP address>) to where the
call is forwarded.
Note: If this field only contains a telephone number and a Proxy isn't
used, the 'forward to' phone number must be specified in the 'Tel to IP
Routing' table (refer to ''Tel to IP Routing Table'' on page 200).
Time for No Reply
Forward
If you have set the 'Forward Type' for this port to 'No Answer', enter the
number of seconds the device waits before forwarding the call to the
phone number specified.