User`s manual

Version 5.4 247 May 2008
SIP User's Manual 3. Web-Based Management
Parameter Description
MWI Suffix Pattern
[MWISuffixCode]
Determines the digit code used by the device as a suffix for 'MWI On
Digit Pattern' and 'MWI Off Digit Pattern'. This suffix is added to the
generated DTMF string after the extension number.
The valid range is a 25-character string.
SMDI (currently not supported)
Enable SMDI
[SMDI]
N/A
SMDI Timeout
[SMDITimeOut]
N/A
3.4.6.2 Configuring RADIUS Accounting Parameters
The 'RADIUS Parameters' page is used for configuring the Remote Authentication Dial In
User Service (RADIUS) accounting parameters.
¾ To configure the RADIUS parameters, take these 4 steps:
1. Open the ‘RADIUS Parameters' page (Configuration tab > Advanced Applications
menu > RADIUS Parameters page item).
Figure 3-99: RADIUS Parameters Page
2. Configure the RADIUS accounting parameters according to the table below.
3. Click the Submit button to save your changes.
4. To save the changes to flash memory, refer to ''Saving Configuration'' on page 265.
Table 3-57: RADIUS Parameters Description
Parameter Description
Enable RADIUS Access
Control
EnableRADIUS
Enables or disables the RADIUS application.
 [0] Disables = disables RADIUS application (default)
 [1] Enable = enables RADIUS application
Accounting Server IP
Address
[RADIUSAccServerIP]
IP address of the RADIUS accounting server.
Accounting Port
[RADIUSAccPort]
Port of the RADIUS accounting server.
The default value is 1646.