User`s manual

Version 5.4 251 May 2008
SIP User's Manual 3. Web-Based Management
Parameter Description
Disconnect Call on
Detection of Busy Tone
[DisconnectOnBusyTon
e]
 [0] Enable = Do not disconnect call on detection of busy tone.
 [1] Disable = Call is released if busy or reorder (fast busy) tones are
detected on the device's FXO port (default).
Disconnect on Dial Tone
[DisconnectOnDialTone
]
The device can disconnect a call after a dial tone is detected from the PBX.
 [0] Disable = Call isn't released.
 [1] Enable = Call is released if dial tone is detected on the device's FXO
port (default).
Note: This option is in addition to the mechanism that disconnects a call
when either busy or reorder tones are detected.
Guard Time Between
Calls
[GuardTimeBetweenCal
ls]
Defines the time interval (in seconds) after a call has ended and a new call
can be accepted for IP-to-Tel (FXO) calls.
The valid range is 0 to 10. The default value is 1.
Note: Occasionally, after a call ends and on-hook is applied, a delay is
required before placing a new call (and performing off-hook). This is
necessary to prevent incorrect hook-flash detection or other glare
phenomena.
3.4.7 Configuring the TDM Bus Settings
The device's Time-Division Multiplexing (TDM) bus settings can be performed in the 'TDM
Bus Settings' page, as described in the procedure below.
¾ To configure the TDM Bus settings, take these 5 steps:
1. Open the 'TDM Bus Settings' page (Configuration tab > TDM Configuration menu >
TDM Bus Settings page item).
Figure 3-101: TDM Bus Settings Page
2. Configure the TDM bus parameters according to the table below.
3. Click the Submit button to save your changes.
4. Save the changes to flash memory, refer to ''Saving Configuration'' on page 265.
5. Reset the device (refer to ''Resetting the Device'' on page 262).