User`s manual

Version 5.4 297 May 2008
SIP User's Manual 4. ini File Configuration
ini File Parameter Description
MIIRedundancyEnable
Enables the Ethernet Interface Redundancy feature. When enabled, the
device performs a switchover to the secondary (redundant) Ethernet port
upon sensing a link failure in the primary Ethernet port. When disabled,
the device operates with a single port (i.e. no redundancy support).
 [0] = Disable (default)
 [1] = Enable
For detailed information on Ethernet interface redundancy, refer to
Ethernet Interface Redundancy on page 445.
Note: For this parameter to take effect, a device reset is required.
DHCPEnable
For a description of this parameter, refer to ''Configuring the IP Settings''
on page 64.
DHCPSpeedFactor
Determines the DHCP renewal speed.
 [0] = Disable
 [1] = Normal (default)
 [2] to [10] = Fast
When set to 0, the DHCP lease renewal is disabled. Otherwise, the
renewal time is divided by this factor. Some DHCP-enabled routers
perform better when set to 4.
EnableDHCPLeaseRenew
al
Enables or disables DHCP renewal support.
 [0] = Disable (default)
 [1] = Enable
This parameter is applicable only if DHCPEnable is set to 0 for cases
where booting up the device via DHCP is not desirable, but renewing
DHCP leasing is. When the device is powered up, it attempts to
communicate with a BootP server. If there is no response and if DHCP is
disabled, the device boots from flash. It then attempts to communicate
with the DHCP server to renew the lease.
EnableLANWatchDog
For a description of this parameter, refer to ''General Parameters'' on
page 166.
DNSPriServerIP
For a description of this parameter, refer to ''Configuring the IP Settings''
on page 64.
DNSSecServerIP
For a description of this parameter, refer to ''Configuring the IP Settings''
on page 64.