User`s manual

SIP User's Manual 350 Document #: LTRT-83303
Mediant 1000 & Mediant 600
ini File Parameter Description
SITQ850Cause
Determines the Q.850 cause value specified in the Reason header that is
included in a 4xx response when Special Information Tone (SIT) is
detected on an IP-to-Tel call.
The valid range is 0 to 127. The default value is 34.
UserToUserHeaderForm
at
Determines the format of the User-to-User header.
 [0] = X-UserToUser (default)
 [1] = User-to-User
RemoveCLIWhenRestric
ted
For a description of this parameter, refer to ''Configuring the Digital
Gateway Parameters'' on page 235.
ScreeningInd2ISDN
For a description of this parameter, refer to ''Configuring the Digital
Gateway Parameters'' on page 235.
ProgressIndicator2ISDN
_ID
For a description of this parameter, refer to ''Configuring the Trunk
Settings'' on page 96.
PIForDisconnectMsg_ID
For a description of this parameter, refer to ''Configuring the Trunk
Settings'' on page 96.
ConnectOnProgressInd
Enables the play of announcements from IP to PSTN without the need to
answer the Tel-to-IP call. It can be used with PSTN networks that don't
support the opening of a TDM channel before an ISDN Connect message
is received.
 [0] = Connect message isn't sent after SIP 183 Session Progress
message is received (default).
 [1] = Connect message is sent after SIP 183 Session Progress
message is received.
SIP183Behaviour
For a description of this parameter, refer to ''SIP General Parameters'' on
page 134.
LocalISDNRBSource_ID
For a description of this parameter, refer to ''Configuring the Trunk
Settings'' on page 96.
PSTNAlertTimeout
For a description of this parameter, refer to ''Advanced Parameters'' on
page 166.
TrunkPSTNAlertTimeout
_ID
For a description of this parameter, refer to ''Configuring the Trunk
Settings'' on page 96.
ISDNTransferCapability_
ID
For a description of this parameter, refer to ''Configuring the Trunk
Settings'' on page 96.
BChannelNegotiationFor
Trunk_ID
For a description of this parameter, refer to ''Configuring the Trunk
Settings'' on page 96.
SendISDNTransferOnCo
nnect
For a description of this parameter, refer to ''Configuring the Digital
Gateway Parameters'' on page 235.