User`s manual

Version 5.4 455 May 2008
SIP User's Manual 8. Networking Capabilities
4. Configure the multiple IP parameters by completing the following steps:
a. In the ‘IP Settings’ page, modify the IP parameters to correspond to the values
shown in the figure below. Note that the OAM, Control, and Media Network
Settings parameters appear only after you select the options ‘Multiple IP
Networks’ or 'Dual IP' in the field ‘IP Networking Mode’.
Figure 8-3: OAM, Control, Media IP Configuration in the IP Settings Page
Instead of configuring in the ‘IP Settings’ page, you can use the 'Multiple Interface
Table' page, which is accessed from the ‘IP Settings’ page by clicking the right-arrow
button alongside the label 'Multiple Interface Table' (refer to ''Configuring the
Multiple Interface Table'' on page 68). The 'Multiple Interface Table' page provides
greater configuration flexibility whereby you can also assign VLANs to the different
interfaces.
Figure 8-4: Multiple Interface Table Page
b. Click the Submit button to save your changes.
Note: Configure the OAM parameters only if the OAM networking parameters are
different from the networking parameters used in the Single IP Network mode.