User`s manual

Version 5.4 503 May 2008
SIP User's Manual 12. OSN Server Hardware Installation
¾ To install the CM module, take these 4 steps:
1. On the Mediant 1000 front panel, use a Phillips screwdriver to remove the black metal
cover plate from the slot located below the module labeled CPU, as shown in the
figure below:
Figure 12-4: Mediant 1000 Front Panel
2. Insert the CM module into the empty slot (below the CPU), with the plain side of the
Printed Circuit Board (PCB) facing up. Ensure the PCB slides into the slot rails, by
aligning the CM with the rails in the slot.
Figure 12-5: Inserting CM Module
3. Gently push the CM module into the slot until it is fully inserted.
4. Using a flathead screwdriver, tighten the module's mounting pins.