User`s manual

SIP User's Manual 506 Document #: LTRT-83303
Mediant 1000 & Mediant 600
12.5 Installing the HDMX Module
The Hard Drive module (HDMX) is installed on the rear panel of the Mediant 1000, as
described in the following procedure:
¾ To install the HDMX module, take these 6 steps:
1. Place the Mediant 1000 so that the rear panel is facing you.
2. Remove the black metal cover plates in the first and second slots located on the right
side of the power connection.
3. Use the cutter tool to remove the small metal strip between the upper and lower slots.
4. Insert the HDMX module into the second slot, as shown in the figure below.
Figure 12-10: Inserting HDMX Module
5. Push the HDMX module into the slot and press on it firmly to ensure it has been fully
inserted.
6. Using a flathead screwdriver, tighten the module's mounting pins.