User`s manual

SIP User's Manual 198 Document #: LTRT-65411
MediaPack Series
Parameter Description
Typically, this feature is used only when early media
(EnableEarlyMedia) is used to establish the voice path before the call
is answered.
Note: This feature is applicable only for one-stage dialing.
Rings before Detecting
Caller ID
[RingsBeforeCallerID]
Determines the number of rings before the device starts detecting
Caller ID.
 [0] 0 = Before first ring.
 [1] 1 = After first ring (default).
 [2] 2 = After second ring.
Send Metering Message to
IP
[SendMetering2IP]
N/A.
Disconnect Call on Busy
Tone Detection
[DisconnectOnBusyTone]
Determines whether the device disconnects the call upon detecting a
busy tone.
 [0] Enable = Do not disconnect call on detection of busy tone.
 [1] Disable = Call is released if busy or reorder (fast busy) tones
are detected on the device's FXO port (default).
Disconnect on Dial Tone
[DisconnectOnDialTone]
The device can disconnect a call after a dial tone is detected from the
PBX.
 [0] Disable = Call isn't released.
 [1] Enable = Call is released if dial tone is detected on the device's
FXO port (default).
Note: This option is in addition to the mechanism that disconnects a
call when either busy or reorder tones are detected.
Guard Time Between Calls
[GuardTimeBetweenCalls]
Defines the time interval (in seconds) after a call has ended and a new
call can be accepted for IP-to-Tel (FXO) calls.
The valid range is 0 to 10. The default value is 1.
Note: Occasionally, after a call ends and on-hook is applied, a delay is
required before placing a new call (and performing off-hook). This is
necessary to prevent incorrect hook-flash detection or other glare
phenomena.
3.5 Management Tab
The Management tab on the Navigation bar displays all menus related to device
management. These menus appear in the Navigation tree and include the following:
 Management Configuration (refer to ''Management Configuration'' on page 198)
 Software
Update (refer to ''Software Update'' on page 210)