User`s manual

SIP User's Manual 272 Document #: LTRT-65411
MediaPack Series
Parameter Description
digits in-band (transparent of RFC 2833) in addition to out-of-band
DTMF messages.
Note: Usually this mode is not recommended.
FirstCallRBTId
For a description of this parameter, refer to ''Advanced
Parameters'' on page 129.
EnableReasonHeader
For a description of this parameter, refer to ''SIP General
Parameters'' on page 101.
3xxBehavior
For a description of this parameter, refer to ''SIP General
Parameters'' on page 101.
EnablePChargingVector
For a description of this parameter, refer to ''SIP General
Parameters'' on page 101.
EnableVMURI
For a description of this parameter, refer to ''SIP General
Parameters'' on page 101.
EmergencyRegretTimeout
For a description of this parameter, refer to “Advanced
Parameters” on page 129.
EmergencyNumbers
For a description of this parameter, refer to “Advanced
Parameters” on page 129.
MaxActiveCalls
For a description of this parameter, refer to ''Advanced
Parameters'' on page 129.
MaxCallDuration
For a description of this parameter, refer to ''Advanced
Parameters'' on page 129.
EnableBusyOut
For a description of this parameter, refer to ''Advanced
Parameters'' on page 129.
EnableDigitDelivery2IP
For a description of this parameter, refer to ''Advanced
Parameters'' on page 129.
EnableDigitDelivery
For a description of this parameter, refer to ''Advanced
Parameters'' on page 129.
Authentication
This ini file table parameter defines a username and password
combination for authenticating each device port. The format of this
parameter is as follows:
[Authentication]
FORMAT Authentication_Index = Authentication_UserId,
Authentication_UserPassword, Authentication_Port,
Authentication_Module;
[\Authentication]
Where,
 UserId = User name
 UserPassword = Password
 Port = Port number
 Module = Module number (0 - 5) N/A
For example:
[Authentication]
Authentication 1 = david,14325,1,$$;
Authentication 2 = Alex,18552,1,$$;
Authentication 3 = user1, 1234,1,$$;
[\Authentication]