User`s manual

SIP User's Manual 286 Document #: LTRT-65411

MediaPack Series

Parameter Description

BlindTransferDisconnectTim

eout

Defines the duration (in milliseconds) for which the device waits for

a disconnection from the Tel side after the Blind Transfer Code

(KeyBlindTransfer) has been identified. When this timer expires, a

SIP REFER message is sent toward the IP side. If this parameter

is set to 0, the REFER message is immediately sent.

The valid range is 0 to 1,000,000. The default is 0.

RejectAnonymousCallPerPor

This ini file table parameter determines whether the device rejects

incoming anonymous calls on FXS interfaces. The format of this

parameter is as follows:

[RejectAnonymousCallPerPort]

FORMAT RejectAnonymousCallPerPort_Index =

RejectAnonymousCallPerPort_Enable;

[\RejectAnonymousCallPerPort]

Where, Enable = accept [0] (default) or reject [1] incoming

anonymous calls.

For example:

[RejectAnonymousCallPerPort]

RejectAnonymousCallPerPort 0 = 0;

RejectAnonymousCallPerPort 1 = 1;

[\RejectAnonymousCallPerPort]

If enabled, when a device's FXS interface receives an anonymous

call, it responds with a 433 (Anonymity Disallowed) SIP response.

Notes:

 This parameter is applicable only to FXS interfaces.

 This parameter is per device.

 This parameter can appear up to 8 times for 8-port MP-11x

devices and up to 24 times for MP-124 devices.

 The double dollar ($$) symbol represents the default value.

 For an explanation on using ini file table parameters, refer to

''Structure of ini File Table Parameters'' on page 233.

IsTwoStageDial