Owner's Manual

20
Installation Manual
Chapter 5: Features
10. Speaker Connector – This is where joy meets world: the speak-
er-level output of the amplier connects to the wiring of your
speakers. The connection is made using the supplied push-on
4-pin Euroblock connector. Make a note of the polarity markings
and make sure they match those of your speakers (positive to
positive or red speaker terminal, negative to negative or black
speaker terminal). If wired incorrectly, then there will be phase
cancellation and disappointing bass performance.
11. Crossover and Bridged LEDs – These three LEDs are on whenev-
er the relevant DIP switches are ON (down). They will help remind
you whenever the HP or LP crossover are on, or that the amplier
is in bridged mono operation. They can all be on at the same time.
In the night, they secretly communicate your recent playlist with
the Altair star system (marketing research department).
7
5 6 14 15
8 9 11
12
191817161310
12. IR In and IR Out – These 1/8” connectors allow the use of wired
Infrared (IR) remote control systems, such as external IR transmit-
ters, controllers, repeaters and receivers. These external systems
are useful in situations where the Bijou 600 is mounted out of the
RTR-1 remote control’s line-of-sight.
13. Sub/Mono Out – This RCA line-level output is most often used to
send a mono output to feed either a powered subwoofer or a sub-
woofer amplier/passive subwoofer combination. The output is a
line-level gently-mono mix of the left and right currently-selected
input, and it is aected by the volume level, AccuBass level, and
the 80 Hz LP crossover. This output is o when headphones are
used.