Owner's Manual

5
The AudioControl Epicenter Micro was designed
to produce bass like you have never heard before.
With that said it is important to take the following
precautions during its use.
1. If you have an equalizer in your system, turn down
the bass frequencies to zero boost.
2. You will want to reduce any other bass tone
control, loudness control, or other secondary bass
controls prior to turning on The Epicenter Micro.
Once your system is up and running, you may
want to use those secondary controls to dial the
bass in a bit more but we doubt it!
3. Good bass response requires an appropriate
choice of speakers and amplification. Since the
bass frequencies always require more power
and cone area than higher frequencies... BE
PREPARED. Small speakers and lack of power will
be detrimental to your system.
The Epicenter Micro needs to be installed in the signal path between a source
and an external amplifier(s). Although it can be installed after an equalizer, it
was designed to be installed before a crossover and other signal processors for
optimal performance.
Once this is done, you just need to hook up power, ground, trigger, run the
wire to the dash remote and tada!!! Instant bass. If you need to know more,
then read on. Even if you don’t think you need to know more, you should still
read on, because you can never know too much.
Quick Start