Owner's Manual
Quick Start Guide
LC-5.1300
6
25. AccuBASS® Threshold – Selects the level at which the AccuBASS®
will begin to work.
26. AccuBASS® Level – Adjusts the level of the AccuBASS®.
27. Crossover Frequency – Selects the LP crossover point to match
your speakers and system. The channel 5 output will receive the
frequency range below the frequency selected.
28. Gain Control – Adjusts the overall 5 output levels.
29. LEDs:
MILC™ Source Clip LED – The MILC™ (Maximum Input Level
Control) patent-pending level-setting circuit prevents clipping
and damaging distortion. It calculates when the waveform of an
incoming audio signal on input 1 and 2 is clipping, and if it is, this
LED will fulll its prime objective and shine forth.
With this advanced feature, you are able to optimize the level of
the incoming audio signals until the Source Clip LED is just-prior
to lighting. If the LED comes on during normal operation, you
should adjust the level of the audio signals before they reach the
LC-5.1300.
Gain Maximized LEDs – These LEDs indicate when the LC-5.1300
amplier gain for channels 1/2, 3/4, and 5 has been maximized for
optimum performance.
AccuBASS® and ACR-1 Notes
AccuBASS®
The AccuBASS is applied to the input signal that feeds the output
of Channel 5. When set to Sum, the input signal for Channel 5 will
be whatever is being received as the Channels 3/4 input. Which, if
that is set to Sum, then the input signal will be 1/2.
ACR-1 remote
The ACR-1 remote level control aects the level of the signal after
the AccuBASS circuit, and the ACR-1 eects Channel 5 output.
The long-awaited moment when “plethora” is used in a manual
The plethora of LC-5.1300 controls allows for a wide variety of in-
stallation possibilities. This quick start guide gives a few examples
of system diagrams, and includes a few notes about the control
settings for each one.
Note: The technical writer reserves the right to be wrong about things, due to the
cold medicine being the night-time sleepy stu, and not the usual day-time strength.