Owner's Manual

Quick Start

Here are a few general steps to get your LC-5.1300 amplier up and

running:

1. Undo the +12V and Ground connections to the car battery

before making any connections to the amplier.

2. Pick a mounting location that will provide access to the controls

and connections, provide adequate ventilation, and also protect

the amplier from heat, moisture, and dirt. Make sure the ven-

tilation slots on the sides are not blocked, and that the heatsink

ns are not covered.

3. The LC-5.1300 amplier needs to be securely mounted using the

four mounting holes located in each corner.

4. Before drilling any holes, take every precaution to prevent

any damage to fuel lines, power and other electrical wir-

ing, hydraulic brake lines, and other systems, that might compro-

mise vehicle safety.

5. When making connections, designate red RCA plugs as right,

and designate white, black, or grey plugs as left. This is a good

idea for consistency.

6. Use quality interconnect cables.

7. Connect the +12V input terminal of the unit to the +12V termi-

nal of the vehicle battery, using 4 to 0 AWG.

8. Connect the Ground terminal of the unit to the chassis of the

vehicle, using the same wire gauge as the +12V power wire.

9. Connect the remote power terminal of the unit to the remote

turn-on switch of your source unit. Alternatively, you can skip

this connection and use the GTO Signal sensing.

10. Connect your audio inputs to the unit – either speaker-level or

line-level RCA… not both.

11. Run the ACR-1 remote to the front of the vehicle to adjust the

level on the y.

12. Connect your loudspeakers (2 Ohm stereo, 4 Ohm Bridged mini-

mum load).

13. When all connections are made, reconnect the vehicle battery.

14. Adjust your input source gain using the MILC Source Clip LED.

This will indicate if the incoming audio signals are clipping.

15. Set the LC-5.1300 crossovers to the frequency recommended by

the loudspeaker manufacturer.

16. Adjust the LC-5.1300 CH 5 AccuBass controls to suit. The ACR-1

adjusts the overall output level.

17. Enjoy the drive!