User Manual

page 11
TROUBLESHOOTING
No Power
If the LED on your dash remote is not on, check the “Power” light on the
chassis of The Epicenter. If the “Power” light is on, you will want to check to
make sure that the cable connecting the remote to the chassis is not pinched or
disconnected. If the “Power” light is off check to make sure that the power
wire and remote turn on wires are connected or a fuse has not blown.
No Restoration
When your system is playing and yet you don’t hear any difference in the
sound, try turning the knob clockwise. If you still don’t hear any affect, then
you need to make sure that you have The Epicenter in the right part of the
signal chain. It must be installed BEFORE any crossovers in the system.
Note: If you are using a source unit with a built in crossover or processor,
you must run a full range output to The Epicenter’s inputs.
Sounds Distorted
Should your system sound distorted or your speakers are moving way too
much, you should decrease the amount of bass restoration by turning the dash
control knob counter-clockwise. You should also raise the PFM frequency or
lower the setting on your Bass Output control.
Still Distorted
Adjust the Para Bass controls by turning the sweep control clockwise to
raise the center frequency. If you still have distortion, you should power down
The Epicenter, remove the cover and change the Bass Output setting to a lower
position (i.e. 2.5 volts).