User Manual

page 4
Quick Install Information
The Epicenter Concert Series needs to be installed in the signal path
between a source and an external amplifier(s). Although it can be installed
after an equalizer, it must be installed BEFORE A CROSSOVER.
Once this is done, you just need to hook up power, ground, trigger, run the
wire to the dash remote and tada!!! Instant bass. If you need to know more,
then read on. Heck if you don’t think you need to know more, you should still
read on, because you can never know too much.
Factory Settings Shipped Options Page #
Para-Bass Frequency 40Hz 27Hz-63Hz 9
Para-Bass Bandwidth Wide Range from 30Hz-250Hz 9
Bass Output Control 5 volts 2.5, 7.5, or 10 volts 10
Input Circuit Balanced Unbalanced 6
Ground Isolation Isolated 200 ohm or Ground 6
Choice of beverage Micro-brew Latté 17
PFM subsonic filter 33Hz 25Hz, 30Hz, 35Hz, 40Hz, 45Hz
Optional PFM modules are sold
separately. 10
Note: These configurations can be changed by moving jumpers, turning knobs
or changing modules.
Figure 1: Quick Install