Owner's Manual

In-Dash
tm
THREE.2
Owner’s Enjoyment Manual
Problem Suggestions
No Sound 1. Is the “Source” button in the wrong position?
2. Is an Aux in plugged in but not turned on?
3. Check “Power” and remote turn on for proper
voltage. (Is power light on?)
4. Center the fader control.
5. Turn up “Input Gain” control.
6. Check ground connections.
Hiss 1. Turn down amp gains
2. Turn down amp gains
3. Turn down amp gains
4. Adjust source unit output
Distorting 1. Adjust equalization levels
Speakers 2. Adjust gain levels
3. Lower volume level of source unit
4. Lower sub level
Whine 1. Confirm that all components are using the
same ground point
2. Change isolation selection of
grounding
jumpers. See page 7, #15
If You Like The THREE.2, You’ll Love...
15
G. Troubleshooting
The Epicenter
®
Con-
cert Series is our patented
(U.S. Patent #4,698,842) bass
restoration component, that
puts the “woof” back into
any woofer. You have to hear
it to believe it.
And now a word from the legal department...
Equipped with 24 dB of gain,
which can increase pre-amp
signal levels up to 9.5 volts
RMS/13 volts peak, the
Matrix Plus line driver will
transform your audio system.