Owner's Manual

D
B
D
II
D
m
Setup
Download the free Audioengine app from the Apple App Store for iOS or
from Google Play for Android. Al-MR setup as well as multi room and stereo
configurations are done via the Audioengine app from an iOS or Android
device.
iOS app
Android app
Connect the included speaker wire from the Al-MR left (powered) speaker to
the right (passive) speaker, observing proper wire polarity to each speaker
connector.
Connect the AC power cable to the Al-MR left speaker rear panel and plug
the other end of the cable into a functioning power outlet.
Turn on power via the rear panel volume/power knob and set the volume to
around 50% so you can hear the audio prompts during setup.
The Al-MR Status button on the rear panel will blink rapidly for 15 seconds,
then a piano tone will play.
The Al-MR Status button will now blink more slowly and a voice will say:
"Entering setup mode. Follow the instructions in the app to finish the
setup."
If no piano tone or voice is heard after 15 seconds, increase the Al-MR
volume level.
Al-MR will remain in setup mode (slow-blinking Status button) for 5 minutes
before timing-out.
To go back into setup mode, press and hold the Al-MR Status button for
about 5 seconds until you hear the voice prompt again.