Owner's Manual
Signal
Turn-On Mode
Offset Rem
GND +12V REM
Connections: A600.1D
GND, +12V, REM: Please see previous
page. These connections are the same
as for the A150.1D. You MUST install a fuse
holder with a 60A fuse within 18” (45cm) of
the battery’s + terminal.
HIGH LEVEL INPUT, LOW LEVEL INPUT: Please
see previous page. These connections are
the same as for the A150.4D with the fol-
lowing exceptions. The A600.1D is a single
channel amplier. You can use one input
or two. If you use two, the output signal
will be the sum of the inputs. If you have a
stereo signal from your head unit, connect
the left and the right output to the inputs.
The output will contain the right and left
signal. Observe proper polarity.
Remote Level Control: Connect the RJ-11
cable between this connector and the
connector on the remote level control. The
remote level control is sold separately. See
the next page for tips about making your
own custom remote level control.
OUTPUT: Connect to a speaker or combi-
nation of speakers with a minimum nal
impedance of 2Ω. The A600.1D is a single
channel amplifier. Two sets of terminals are
provided to make connecting two speak-
ers easy. The two + terminals are common
inside the amplifier. The two - terminals are
also common inside the amplifier.