Owner's Manual
6:
Operation
- 2
Operating Modes
Although
the
6000A
is
an integrated amplifier
it
can function
as
a separate
Pre and Power amplifier.
Use
the
MODE
knob
on
the
front
panel,
or
the
MODE key on
the
Remote
control,
to
select
different
operating modes.
MODE
POWER
AMP
IN
PRE
OUT HEADPHONE OUT
PRE
DISABLE
ACTIVE
ACTIVE
PRE
-
POWER
ACTIVE
ACTIVE
ACTIVE
INTEGRATED
DISABLE
ACTIVE
ACTIVE
Integrated mode
MODE
0
LOUDSPEAKERS
DISABLE
ACTIVE
ACTIVE
The pre-amplifier section
is
internally connected
to
the
power
amplifier, Pre
-a
mplifier
output
is
also
operational in this mode. A second
power
amplifier can be connected
for
bi
-a
mplification
as
shown
in
the diagram.
"
□
'"
@)
·@)
<®
·
((
G~.,
'
!
•
g i
t
-
@) @)
-
::a:
0 I
~
I
•
·I
Pre-Power mode
The
pre-amplifier section
is
internally disconnected from the power amplifier. The
6000A
can
be
used
as
a stand alone power amplifier
(ie.
part
of
an
AV
setup). This
mode
can
also
be
used if additional
signal
processing
is
required, connecting the
Pre
-
out to
an
external signal processor and then take the output from the processor to
the 6000A Power-
IN.
POWER
Pre Mode
All
signals to and from the power amplifier
of
the 6000A are disconnected.
In
this
mode, the 6000A functions
as
a stand-alone pre-amplifier.
The
pre-amplifier section
of
the 6000A
can
be
connected to a stereo power amplifier,
or
to two mono-block
amplifiers.
@)
audiolab
~-ir~-
-,
~
I
~
~
@@@@@c
@
@)
-c
l[J
@ @ @ I©
©@©©@•.i,,
®
..
-@
-~··
,
_J_
__
m,-~o-m,--J
Output
to
the
Ex
ternal
power
amplifier