Owner's Manual

Connect power to all system units. Switch the mains on. Switch on all source units including
the 6000CDT. Switch on the power amplifiers.
When switching off: switch off the amplifier first before switching off the 6000CDT unless
they are trigger enabled.
When switching on: The power LED illuminates, the display shows the welcome screen. After
a short period the unit boots up.
The 6000CDT will enter standby mode after being powered on. Press the “Standby” button to
bring the 6000CDT out of standby, the power indicator LED becomes brighter and the display
shows “6000CDT” welcome screen while the unit is getting ready for operation.
The Auto Standby feature will, by default, put the unit into standby after 20min of inactivity.
This feature can be configured by holding the standby button for 3 seconds and be set to
20min, 1hour or Never.
Insert one CD into the slot. The disc information will now display. After reading the track
information the disc will stop.
6: Operation
Page 6
Switching On and Off
Standby Mode
Loading a Disc
Playing a Disc
Press to play a disc.
Press to pause a disc, press again to resume play
Press to stop the disc
Press to eject the disc
Next/Previous Track
Press to move to the next track.
Press once to replay the current track,twice to move to the previous track.
Press
/ repeatedly to move through the tracks forward or back on track at a time.
If you exceed the number of tracks on the disc, the player will wrap round and play from track
1.
If you go past track 1, the player will wrap round and reverse search from the final track on the
disc.
Forward and Reverse Search during play
Press and hold the / on the handset. The forward and reverse search will start.
Direct selection of the tracks from the handset
When in PROG mode, the time dot is flashing.
Track Time Display
When in PROG mode, press the Repeat key on the handset to repeat all chosen tracks.
Display Setting
Pressing the DISPLAY button on the remote to control the display ON/OFF.
Select the wanted track directly from the remote key pad. The disc will play forward from the
chosen track. If you choose a single digital track (e.g.1) in a disc which contains more than 10
tracks, the player will pause briefly, waiting for you to enter a second digit. If none is entered,
player will commence from the entered single-digit track. If the choice is invalid the display
reverts to the previous state.
You can create a custom program of up to 99 chosen tracks. .
Program mode must be accessed when the disc has stopped.
Press PROG to enter program mode. Insert the a track number, press STORE to save.
To play the program: Press
To stop program play: Press
To erase a program from memory: The program is stored in the player’s memory until erased.
When the display is OFF: Pressing any key will momentarily switch the display on. After a few
moments the display will go off.
Repeat Play
Press the Repeat key on the handset to repeat all tracks on the disc continuously.
Press the Time key to toggle track time remaining and elapsed
Program Play