Instruction manual

7d: Setting Up the 8000AP - 4
Other Options
• Press to
display the setup
page.
• Press the
keys to select
Other Options
Press
This is a special setting for 2ch. PCM / analogue only and
does not otherwise affect the normal working of the Bass
manager. If you want subwoofer output from stereo material
when using large front speakers use this setting
- No subwoofer out from stereo material when L & R
speakers are set to Large.
. The low bass output of both channels is
mixed to mono and fed to the subwoofer.
If your speakers are large truly full range models you may
prefer the purist view and disable the subwoofer in Stereo. As
always, personal preferences will come into play.
You can set the DAC filter to or
The filter has better technical performance and best
attenuation of spurious signals but sounds “mechanical” to
many people. The filter has improved group delay
characteristics and a gentler roll off but could result in higher
spurious noise levels.
Upsampling applies only to Audio PCM or HDCD streams.
The default setting is “Off”. Setting upsampling ”On” pushes
the noise spectrum further up the band resulting in an
increased “airy” sound which many prefer. We suggest you
listen with upsampling on and off and choose accordingly.
Select YES to reset the system setup parameters to factory
defaults. After a short pause the 8000AP responds with the
message “DONE” and the default status is re-established.
MENU
• ENTER
Bass Manager
Normal
L+R to Subwoofer
DAC Filter
Fast Slow.
Fast
Slow
Upsampling
System Reset

. The choices
are:
Page 12