User guide

SETUP AUDIOLINE TAM838

OUTGOING MESSAGE (OGM)

The system has a built in announcement message. “Hello please leave a message after

the tone”. You can use this message or record your own.

To record your own announcement message:

# Ensure the machine is switched on.

# Press and hold the [ANNC/DAY] button, display shows “A1”.

# After a beep tone record your message (maximum: 30 seconds).

# When finished, release [ANNC/DAY] button, your greeting will now replay.

# Repeat procedure if you wish to change your announcement message. To revert

back to the pre-recorded announcement, press the [DELETE] button during

playback of your announcement.

SETTING THE CLOCK

# Press and hold [TIME SET/CHECK] button you will hear a beep, at the same time;

# Press and release the [ANNC/DAY] button repeatedly to set the day. The display

will show 01 = Monday 02 = Tuesday etc, then;

# Press and release the [2WAY/HOUR] button repeatedly to set the hour. The display

will show the hour 01, 02 etc and announce am/pm, then;

# Press and release the [MIN] button to set the minutes. The display will show the

minute (press and hold to advance by 10 minute steps).

# Release the [TIME SET/CHECK] button. The unit will announce the time set.

# If you make a mistake, repeat the above procedure.

# To check the settings, press and release the [TIME SET/CHECK] button. If ‘Please

set time’ is announced, the time has not been set.

NOTE: If you do not set the time, the system will not announce the time each

message was received.

ANSWERING CALLS

The switch 2/7/TS at the side of the system determines how the system answers calls.

2 = the system will answer a call after 2 rings

7 = the system will answer a call after 7 rings

T/S = the system will answer a call after 2 rings if new messages are recorded and

after 4 rings if no new message exists.