User guide

4
AUDIOLINE TAM838 USING THE ANSWERING SYSTEM
VOLUME CONTROL
# Press the • – buttons to increase/decrease volume.
LISTENING TO YOUR MESSAGES
# The display flashes to show how many new messages have been received. If no new
messages have been received the display shows total messages (old).
# Press [PLAY/PAUSE] to listen to your new messages (when NEW messages have
been played, press [PLAY/PAUSE] again to play all messages).
# You have the following options during playback:
Press [SKIP] to skip current message.
Press [REPEAT] to replay current message.
Press and hold [REPEAT] for 1 second to play previous message.
Press [DELETE] to erase current message. (See Warning below.)
To pause playback press [PLAY/PAUSE] (“P” will show in the display, after 7
seconds the unit will revert back to standby mode), to continue press [PLAY]
again.
To erase all messages after playback, press and hold [DELETE] until unit
beeps.
Warning: Deleted messages CANNOT be retrieved.
NOTE: If the display shows “--” either the OGM is missing or the day/time has
not been set.
CALL SCREENING
# With the unit switched on, incoming messages can be heard before deciding
whether to answer calls. Adjust the volume setting using the • – buttons.
# To turn the speaker down, repeatedly press the – volume button.
# To turn the speaker up, repeatedly press the • volume button.
INTERCEPTING MESSAGES
# If, while listening to a message being recorded you decide to answer a call, lift the
handset on a telephone connected to the same telephone line.
# If recording continues, press [STOP] on the TAM838, or “t ” on the tone
dialling telephone you are using.