Operating instructions

14
Operating the Walkie−Talkies
30
Resuming channel scanning
X or Y Resume channel scanning
Excluding a channel
If a channel found during the channel scanning process should
not be considered for subsequent use, it can be excluded.
All the channels are taken into consideration again when a new
channel scan is started. During the time that the walkie−talkie is
temporarily stopped on the unwanted channel, press and hold
the X / Y for 3 seconds to exclude that channel.
a, 3 sec. X or Y The channel is excluded and
channel scanning automatically
resumed
Transmit ringing tone
The ringing tones indicate to other subscribers that you want to
talk to them. A condition for this is that the other subscribers are
using the same channel and CTCSS/CDCSS code.
T Send ringing tones
Selecting/Deactivating the ringing tone
There are 10 ringing tones available for selection. To deactivate
the ringing tone, select the setting 0" (zero).
3 x M Activate programming mode
X or Y, P Select the ringing tone and
confirm it
Monitor
The Monitor function enables the search for weak signals on the
channel currently set. If you receive an external signal, switch to
a free channel. Always communicate with other subscribers on a
free channel to prevent interference.
a, N Monitor the channel
b, N End the monitoring function
Service−Hotline Germany: Tel. [phone] (cost via Telekom at time of going to print: 14 ct/min)