Operation Manual

- Operation -

4.2 Receiving calls

When a call arrives, the ringing tone sounds on the handsets and on the base

station. The handsets will ring a little later than the base station due to the radio

transmission. The message EXT. will flash in the display. Press the call button

on one of the handsets and the connection will be made. The call indicator

on the base station will flash during the call.

Note: While the handset is ringing, you can adjust the ringer volume by means

of the

and

buttons.

To end the call, replace the handset in the base station or press the call button

on the handset.

Notes: Please refer to Chapter 6 for information on how to show the caller's

number in the display. When the automatic call accept feature is selected, the

call is automatically accepted as soon as you lift the handset from the base

station or charger. You can find out in Chapter 8.5 how to switch the automatic

call accept feature on or off.

4.3 Making calls

1. Enter the required telephone number with a maximum of 32 digits using

the number pad. As the display is only capable of showing 12 digits, in

the case of longer phone numbers only the last 12 digits are displayed.

Note: If you have entered a number incorrectly, you can delete the number by

repeatedly pressing the

button. The number is completely deleted by

pressing the

button for a long time.

2. Press the call button and the required connection will be made.