Operation Manual

- Operation -

Note: You can also get a dialling tone by first pressing the call button

. On

entering the digits of your required phone number, your telephone will dial the

number directly. With this method of making a call, it is not possible to correct

individual digits in the number in the manner described above.

4.4 Dialling stored numbers from the phone book

After you have stored a few phone numbers (refer to chapter 5.1), you can call

these up very quickly and easily.

1. Press the phone book button

. The display will now show the first

number stored in alphabetical order.

2. You can now select all of the stored numbers with the and

buttons.

To choose a phone number directly alphabetically, press the appropriate

letter.

3. Now press the call button and the telephone number displayed will be

automatically dialled.

4.5 Call duration display

The call duration in hours, minutes and seconds is shown in the display during a

call. Ten seconds after dialling, the display will switch from showing the number

dialled to showing the duration of the call. The display will show the duration of

the call and the name of the mobile unit alternately for a few seconds after a call

has been ended.

4.6 Switching the handset on and off

You can switch off the handset by pressing and holding the

button. If the

handset is switched off, no battery power will be used. It will not be possible to

receive calls.

Press the

button once to switch the handset on again. The display will

show the message BASE 1 and the handset will switch on again after a short

time. The handset will switch itself on automatically as soon as you replace it on

the base station.