Operation Manual

- Multiple handsets -

9.4 Logging on and logging off handsets

9.4.1 Logging on 5400TECH handsets

1. Press and hold the page button

on the base station for 3 seconds

until you hear two signal tones. Now log on the new handset to the base

station within 90 seconds.

2. Press the

button on the handset.

3. Select the REGISTER menu with and

and confirm with

4. Select the REG BASE menu with and

and confirm with

5. Now enter the number of the base station (1 - 4) using the number pad. If

the handset is already connected to a base station, the corresponding

numbers will flash.

6. Confirm your entry with the

button. A search will now be carried out for

the base station.

7. After the base station has been found, you must enter the PIN Code

(factory setting 0 0 0 0).

8. Confirm your entry with the

button and after a few seconds you will

hear a signal tone. The handset is now logged on and can be used for

external and internal calls.

9. An internal number will now have been allocated to the handset. The first

handset registered (main handset) has the internal number 1. Any further

handsets that are registered are allocated internal numbers (2 to 5) in the

order of registration. This internal number is shown in the display on the

right side.

9.4.2 Logging on other DECT-GAP telephones to the base station

In order to log on a DECT-GAP handset, follow the instructions in the other

supplier's operating manual and then press the

button on the base station

for 3 seconds. Use the PIN-Code 0 0 0 0 to log on.