Operation Manual

- Setting up -
26
3 Setting up
3.1 Check contents of pack
The following items are supplied
one parent unit including belt clip charging station for parent unit including power supply
one baby unit Plug-in power supply for baby unit
2 rechargeable standard batteries for parent unit one instruction manual
3.2 Parent unit
3.2.1 Fitting standard batteries
Open the battery compartment on the parent unit by pushing up the battery compartment cover by its bottom end. If the belt clip
has been fitted, this must be removed first. Now insert the standard rechargeable batteries taking care to ensure that the polarity is
correct. Close the battery compartment cover.
NOTE:
Do not use normal, non-rechargeable batteries in the parent unit.
Never use the parent unit on the charging station without standard rechargeable batteries.
3.2.2 Fitting or removing the belt clip
To fit the belt clip, place the top end into the parent unit and then
press the belt clip downwards. To remove the belt clip, use a
screwdriver to press on the retainer inside the clip and pull the
belt clip upwards.
Fitting the clip Removing the clip
3.2.3 Connecting the charging station
The plug-in mains power supply is permanently connected to the charging station. Plug the power supply into a properly installed
230 V mains socket.