Operation Manual

- Operation -
35
4.12 Searching for the parent unit
If you cannot remember where you have left the parent unit, press the PAGE button (3) on the baby unit. You will hear the call
signals from the parent unit for 2 minutes and thus be able to find it again easily. You can cancel the audible signals prematurely
by pressing any button on the parent or baby unit.
Note: If the volume on the parent unit is switched off, this will be automatically reset to a medium volume.
4.13 Monitoring the radio contact
The radio contact between the parent unit and the baby unit is monitored continuously. When there is a good connection, the
green LINK indicator light (18/11) on the parent and baby unit illuminates.
If you have moved the parent unit too far away from the baby unit or if the baby unit is switched off, the green indicator light will
flash and you will hear a warning tone every 30 seconds. After this, the indicator light will flash red, the message NO CONTACT
will appear in the display and you will hear a warning tone every 30 seconds.
Note: The warning tone for loss of radio contact cannot be switched off. However, the warning tone can be silenced for 3 minutes
by pressing any button on the parent unit.
4.14 Restoring factory settings
The factory settings can be reset individually on the parent and baby unit.
Switch on the parent or baby unit.
While all the indicators are on, press the volume button (4= Baby unit, 20= parent unit) immediately until RESET appears in
the display. The reset will be carried out after a few seconds.
Factory settings, baby unit Factory settings, parent unit
Volume: Step 3 Volume: Step 1
Lullaby: 1 Sensitivity Step 5
Temperature monitoring: Minimum 14°C, Maximum 23°C Warning tone: On
Temperature monitoring: Off