Operating instructions

- Setting up -
27
3.2.4 Charging the parent unit
Place the parent unit in the charging station with the display to the front for at least 16 hours. The charge monitoring light on the
charging station will come on and charging will be indicated by a cycling display of the battery symbol. When the parent unit is fully
charged, the display will show a complete battery symbol. The standard rechargeable batteries have an operating time of max. 12
to 24 hours at room temperature.
The current battery capacity is shown in the display.
Full
Half
Low
If the battery capacity is too low, an appropriate message will appear in the display and you will hear a warning tone every minute.
The parent unit must only be used for a further 1 hour after the first warning tone.
3.3 Baby unit
Note: The baby unit is designed for operation with the plug-in mains power supply provided. The baby unit can be
operated with four 1.5V AA alkaline batteries (not included) as a backup in the case of supply failure or for short-term
operation in battery mode.
3.3.1 Connecting the power supply
Use the plug-in mains power supply provided for the baby unit. Insert the small round plug into the socket provided on the rear of
the baby unit (13) and plug the power supply into a mains socket (230V/50Hz). Ensure that the plug-in mains power supply is
adequately ventilated.
3.3.2 Fitting batteries as a backup in the case of supply failure or for battery mode.
The baby unit is designed for operation with the plug-in mains power supply provided. The baby unit can be operated with four
1.5V AA alkaline batteries as a backup in the case of supply failure or for short-term operation in battery mode. In this case, the
baby unit can be used for 16 hours with new batteries and the message BATTERY will appear in the display.
If the battery capacity is too low, an appropriate message will appear in the display and you will hear a warning tone every minute.
The baby unit can be used for a further 1 hour after the first warning tone.
Open the battery compartment on the rear using a coin and insert the batteries. When doing so, take care to ensure that the
polarity is correct and close the battery compartment.